How do I make a beaded door with beer bottle caps? - bead cap charms
I want to find a piece of wood, as your way to the door and smudge-proof. (about 2 cm wide), then I will the small bolts that have a circle at the end and buy passport. You need a hole in the upper and lower lids. Use a needle and thread fishing line. Place a small dot of clear glue on the hole in the top and bottom to keep him. I saw where the neon straws to use Inbetween parties. Finish with a bottle. Or you can have two bottle caps in a piece of tape and place floor where you want it. ) (Back. Connect them with screws.
Good luck
Tuesday, January 12, 2010
Bead Cap Charms How Do I Make A Beaded Door With Beer Bottle Caps?
3 comments:
In fact, one of these
I pounded 2 holes in the cover (with a nail to make the hole)
Then select, with each tape / rope, you pull the string in a hole and another and slide the heel.
You can have multiple hats, or they just hate.
I have a piece of wood than my head,
Lacquered Design Fashion
Staples then the string to the Board.
Get a long piece of string, and a half times the length of the door. Knot the string you are door.Get nodes above and below the cap bottles of beer and a pair of pliers, crimp the cap on the node string.It easier than putting holes in caps. Have.Get Then with the piece by dowel pins or shafts provider of drilling in wood for as many channels as two great curtain hooks on each side of the door, hanging wood screws, the curtain.
Get a long piece of string, and a half times the length of the door. Knot the string you are door.Get nodes above and below the cap bottles of beer and a pair of pliers, crimp the cap on the node string.It easier than putting holes in caps. Have.Get Then with the piece by dowel pins or shafts provider of drilling in wood for as many channels as two great curtain hooks on each side of the door, hanging wood screws, the curtain.
Post a Comment